Main
unit
VOLT
ADJ
r---Iilh
nO-l27V
22C-240V
Aim
at
the remote control signal sensor
(q
39), avoiding obstacles, at a
maximum range
of
7 m (23
ft)
directly in front
of
the unit.
Do not:
• mix old and new batteries.
• use different types
of
batteries at the same time.
• take apart or short circuit.
• attempt to recharge alkaline or manganese batteries.
• use batteries
if
the covering has been peeled off.
Mishandling
of
batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
mm
The included AC power supply cords are for use with the main unit and
wireless system only. Do not use them with other equipment. Also, do
not use cords for other equipment with the main unit or wireless system.
Press [POWER ...
I,"
<9]
on the wireless system.
Unit
on/off
button
[POWER
..
I,
I
~]
Use this button to turn the wireless system on and off.
..
I:
The wireless system
is
on.
I 6: The wireless system is off.
WIRELESS LINK
indicator
Red: The wireless system is on and the wireless link is deactivated.
Green: The wireless system
is
on and the wireless link is activated.
("
~.
is also displayed on the main unit's display.)
• If
the
AC
plug
does
not
fit
your
household
AC
outlet
Use the AC plug adaptor
(induded).
If it still does not fit, contact an electrical
parts distributor for assistance.
Before
connecting
the AC
power
supply
cord
Set
the
voltage.
Use a flat-head screwdriver to move the
voltage selector to the appropriate position
for the area in which this system is used.
'4.11";'"-*4
'3g.
i
•
IL
i'.Mi,j,I+i,Fi·n
,
,
:_.
~ ~
~ ~
J
step
4
AC
power
supply
cord
connections
oReplace the cover.
e Insert so the poles
(+
and
-)
match those
in
the remote control.
step
6
Preparing
the
remote
control
To
household
AC
outlet
CAUTION
Danger
of
explosion
if
battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose
of
used batteries according to the manufacturer's instructions.
Wireless
system
Wireless
system
• Use alkaline or manganese batteries.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period
of
time with doors and windows closed.
Turn on the wireless system after all connections are complete.
step
5
Preparing
the
wireless
system
Conserving
power
The main unit and the wireless system consume a small amount
of
power when they are turned off
(ImIIm'+"6!.!iI
main unit: approx.
0.1
W,
wireless system: approx. 0.2
W,
mmmain unit: approx. 0.2
W,
wireless system: approx. 0.3 W).
To
save power when they are not to be
used for a long time, unplug them from the household AC outlet.
You
will need to reset some memory items after plugging in the main
unit.
To Next Page
Loading...
