Panasonic SC-PT770

Basic play
If you are experiencing problems, refer to troubleshooting (0) 32 to 33)
Preparation
To display the picture, turn on your TV and change its video input mode (e.g. VIDEO 1, AV 1, HOM!. etc.) to suit the connections to this unit.
Using the main unit
1 [POWER<.!>~
Turn on the unit.
2 ~LECTOR
Select "DVD/CD".
3 I ~ OPEN/CLOSE b
Open all the disc trays.
• To select a desired tray (0) below, Selecting the desired tray).
• Press
[~OPEN/CLOSEl again to close all the disc trays.
Start play.
• Turn [-, + VOLUME) to
adjust the volume.
~Label
~"'ci"9"P
4 Load the disc.
• Load double-sided discs so the
label for the side you want to play is
facing up.
• Press [EXCHANGE) to load discs
one
by one.
• For DVD-RAM, remove the disc
from its cartridge before use.
• Do not:
- Load more than one disc per tray.
- Push or pull out the tray by hand.
Pull open
CD 0 ® @
5 DISC SELECTOR
®
0
Tl
'NEGh
... i... ~/~
Press to select a disc directly.
• You can also select the disc using the remote
control
(0) 19, Selecting a disc).
Press to skip.
Press and hold to:
- search during play
- start slow-motion play during pause
• Press
[~l (Play) to start normal play.
~CHANGE
• All trays are opened (except the tray where the disc
is playing).
• Press [EXCHANGE] to
dose the top tray.
Press again until all the trays are
dosed
• Press [~OPEN/CLOSEl to close all the open trays.
. During play,
o ® @ ®
5 DISC SELECTOR
CD
~ OPEN/CLOSEb
, Press [~OPEN/CLOSEI again to close the tray_
N
N
a
~ ..
ii1 • DISC CONTINUES TO ROTATE WHILE MENUS ARE DISPLAYED.
To preserve the unit's motor and your TV screen, press [_j (Stop) when you are finished with the menus.
_ • Total title number may not be displayed properly on
+RI+RW.