Selecting the playback source
iPod
(Q
26)
DVD/CD
(Q
12)
Ea'ChTimeyoupress-ihe'6ution:"~"--~--~
FM
(Q
13)
AM
(Q
13)
AUX":
For
audio input through the AUX
terminal.
D-IN':
For
audio input through the
OPTICAL IN terminal.
(Q
below)
" "(TV)" will appear beside "AUX"
or
"D-IN",
indicating the
TV
audio setting for
VIERA
Link "HDAVI Control"
(Q
24).
Selecting
the
source
by
the
remote
control
PCM
FIX
mode
PCM
ON: Select when receiving only PCM signals.
pCM
OFF: Select when receiving Dolby Digital and
PCM
signals.
(When receiving true 5.1-channel surround sound, select "PCM OFF".)
mIll
• Audio that is input through the OPTICAL IN terminal is not output from
the HDMI terminal.
• Underlined items in the above paragraph are factory settings.
MAIN/SAP
mode
(Only works with Dolby Dual Mono):
MAIN,
SAP",
MAIN+SAp'
(stereo audio)
" "SAP" = Secondary Audio Program
Dynamic
Range
Compression
DRC ON: Adjust for clarity even when the volume is low by
compressing the range
of
the lowest sound level and the
highest sound level. Convenient for late night viewing.
(Only works with Dolby Digital)
pRe
OFF:
The
full dynamic range
of
the signal
is
reproduced.
Select to suit the type
of
audio from the OPTICAL IN terminal on the main
unit.
While in "D-IN" mode
Press
[SETUP]
to
select
"MAIN/SAP",
"DRC"
or
"PCM
FIX".
2 While the selected
mode
is displayed
Press
[.l.
~]
to
make
the
setting.
Press [SELECTOR) on the main unit to select source from the main unit.
(Q
39)
mIll
Confirm the audio connection to the
AUX
or
OPTICAL IN terminal
on
the
main unit when you select the corresponding sources
(Q
9). Reduce the
volume on the
TV to its minimum and then balance the TV volume with
the volume setting on the main unit. Refer also to the operating
instructions for your
TV to balance the sound.
Home
theater
.t.,'f'
OK
START
=e...-.-
RADIO, EXT-IN
tJJ
4
OVDICD
Make the setting.
Select an item.
•
To
exit, press [START].
Show~th-e~SfART··menu.---·~·~·
This unit automatically turns on.
(The
TV
also turns on when using
VIERA
Link "HDAVI Control". Thisworks only when
in "DVD/CD"
or
"IPOD" mode without any
disc/device being loaded/connected.)
e.g.
DVD
j"""-~'-J";'
iPod
SETUP
When
"Input
select"
is
selected
You can select a desired source from the menu.
• DVD/CD
(Q
12), FM
(Q
13),
AM
(Q
13),
AUX"
(Q
right),
DIGITAL
IN"
(Q
right), iPed
(Q
26)
""(TV)" will appear
beside"
AUX"
or
"DIGITAL IN", indicating the TV
audio setting for
VIERA
Link "HDAVI Control"
(Q
24).
When
a
disc
is loaded, you can also access playback
or
menus
from the
START menu.
e.g.lovo-vl
Selecting
the
source
from
the
START
menu
!
OYD~;CD~~~§!5~E~!-
Playback/menu access
You can select desired source
or
access playback/menus by using the
START menu.
When
the on-screen control panel appears
e.g.lovo-vl
(when "Playback Disc"
is
selected from the START menu)
You can operate the playback with the indicated controls.
-
To Next Page
Loading...
