Setting up the radio (continued)
Il
Ie
FM
frequency step
Main
unit
only
The step is factory-set to 0.2-MHz, but you can change it to receive
broadcasts allocated in
0,
1-MHz steps.
You
may need to change this
setting
if
the tuner seems to skip over the correct frequency for stations
in
your area.
CD
Press
[SELECTOR]
to
select
"FM".
@
Press
and
hold
[SELECTOR].
After a few seconds the display changes
to
show the current minimum
frequency. Continue to hold the button down. The minimum frequency
changes and the step is changed.
e.g. 87.9 (Factory preset)
........
87.5
To
return to the original step, repeat steps
CD
and
@.
miD
After changing the setting, previously preset frequencies will be cleared.
Preset them again,
Alternatively, press
[v,
A).
and then press [OK].
Main unit:
CD
While listening
to
the radio broadcast
Press
[MEMORY] twice.
@ While a channel number is flashing on the display
Press
[v
TUNE
A],
and
then
press
[MEMORY].
A station previously stored is overwritten when another station is stored
in
the same channel preset.
JIiIfj
""
,"
,j
:',
'
__
,Ui;l;;;,r"
""".
Up to 30 stations can be set in each band, FM and AM.
CD
While listening to the radio broadcast
Press
[OK].
@ While the frequency is flashing on the display
Press
the
numbered
buttons
to
select
a channel.
•
To
select a 2-digit number
eg,
12:
[~10)
~
(1)
~
(2)
OK
Numbered
buttons
N
N
g
a::
-
To Next Page
Loading...
