Discs — Changing the player settings
Discs — Changing the player settings
24
STILL MODE
Specify the type of picture shown when
paused.
AUTO
FIELD
4
: The picture is not blurred, but picture quality is lower.
FRAME
4
: Overall quality is high, but the picture may appear blurred.
VIDEO OUT (I/P)
Select “PROGRESSIVE” only if
connecting to a progressive output
compatible television.
INTERLACE PROGRESSIVE
When you select “PROGRESSIVE”, a message screen will appear.
For progressive output, press [e] and then press [OK].
Press [ , RETURN] to cancel.
“VIDEO” menu (continued)
“AUDIO” menu
SETTING STATE Display the current setting of the items below
REGISTRATION
Displays the unit’s registration code.
SHOW CODE: You need this registration code to purchase and play DivX Video-on-
Demand (VOD) content (
page 7, ABOUT DIVX VIDEO-ON-DEMAND).
JPEG TIME To change the slideshow timing
1 SEC to 15 SEC
(in 1 unit)
15 SEC to 60 SEC
(in 5 unit)
60 SEC to 180 SEC
(in 30 unit)
“3 SEC” is the factory preset.•
EASY SETUP SET: Display the EASY SETUP settings
DVD-VR/DATA
Select to play only DVD-VR or DATA
format.
DVD-VR: To play the video programs on DVD-RAM or DVD-R/RW.
DATA: To play the data files on DVD-RAM or DVD-R/RW.
SCREEN DIMMER
This is to prevent burn mark on the
television screen.
OFF
WAIT 5 MIN: If there is no operation for 5 minutes, the pictures turns grey. The
television screen would resume when you perform some operations. (This does not
work during video playback.)
DEFAULTS
This returns all values in the Setup menus
to the default settings.
RESET
The password screen is shown if “RATINGS” (
page 23) is set. Please enter the
same password and press [OK], then turn the unit off and on again.
DivX
“OTHERS” menu
“DISPLAY” menu
SETTING STATE Display the current setting of the items below
LANGUAGE
Choose the language for the on-screen
messages.
ENGLISH
繁體中文
SETTING STATE Display the current setting of the items below
DOLBY DIGITAL BITSTREAM
PCM
Select “BITSTREAM” when the equipment can decode the bitstream
(digital form of multi-channel data). Otherwise, select “PCM”. (If the
bitstream is output to the equipment without a decoder, high levels of
noise can be output and may damage your speakers and hearing.)
DTS BITSTREAM
PCM
DYNAMIC RANGE ON: Adjusts for clarity even when the volume is low through compressing the range
of the lowest sound level and the highest sound level. Convenient for late night
viewing. (Only works with Dolby Digital.)
OFF
SPEAKER SETTINGS SETTINGS:
C DELAY: 0ms, 1ms, 2ms, 3ms, 4ms, 5ms
Select the delay time for your center speaker
( page 25, Changing the delay time (Speaker settings)).
LS/RS DELAY: 0ms, 5ms, 10ms, 15ms
Select the delay time for your surround speaker
( page 25, Changing the delay time (Speaker settings)).
TEST TONE: SETTING
Use the test tone for speaker level adjustments
( page 25, Adjusting the speaker level).
CENTER, SURROUND RIGHT, SURROUND LEFT: –6dB to +6dB (Factory
preset: 0dB)
•
•
•
Discs — Changing the player settings (continued)
4
Refer to “Frame still and field still” (
page 40, Glossary).
To Next Page
Loading...
