Using other equipment
Auto-off function/Using other equipment
35
The remote control and main unit are factory-set to “REMOTE
1” mode.
If your remote control affects other equipment during operation,
you can switch to operate in “REMOTE 2” mode.
To switch to “REMOTE 2” mode
1 While pressing and holding [EXT-IN] on the main unit
Press and hold [2] on the remote control until “REMOTE 2”
appears on the main unit display.
2 Press and hold [OK] and [2] on the remote control for at
least 2 seconds.
The main unit and remote control are now set to operate in
“REMOTE 2” mode.
To return to “REMOTE 1” mode
Perform steps 1 and 2 but use [1] instead of [2] for both steps.
(“REMOTE 1” appears on the main unit during step 1.)
The remote control cannot work with the main unit if their
modes are different.
“REMOTE 1” or “REMOTE 2” appears on the main unit display
when you operate the remote control.
If “REMOTE 1” appears (The main unit is in “REMOTE 1”
mode.)
Press and hold [OK] and [1] on the remote control for at least
2 seconds.
If “REMOTE 2” appears (The main unit is in “REMOTE 2”
mode.)
Press and hold [OK] and [2] on the remote control for at least
2 seconds.
You can still operate a television using the remote control
( below) even after switching the mode.
Changing the main unit and
remote control mode
Operating a Panasonic television
Some models cannot be operated by this remote control.
Aim the remote control at the television for the following
Note
Turning the television on/off
Switching the television’s video input mode
Adjusting the volume
Using other equipment (continued)
You can connect to an analogue player with a built-in phone
equalizer.
1 Press [EXT-IN] repeatedly until “AUX” is displayed.
2 For listening : Proceed to step 3.
For recording : Press [* REC, TAPE] on the main unit to
start recording (Recording page 27).
Press [* REC, USB] on the main unit to
start recording (Recording page 28).
3 Playback from the external source.
For details, refer to the instruction manual of the unit which is
to be connected.
When units other than those described above are to be
connected, please consult your audio dealer.
Sound distortion may occur when you use an adaptor other
than the one supplied.
•
•
•
Note
“LINE OUT” position
Rear panel
of this unit
Analogue player
(not included)
To Next Page
Loading...
