Panasonic SDR-S150 - If the driver has not been recognized properly

91
VQT0X39
∫ If the driver has not been recognized properly
[!] or [Unknown device] appears at [USB (Universal Serial Bus) controller] or [Other
devices], etc.
(Where the display will appear depends on the type of PC you are using.)
Disconnect the USB cable, uninstall then re-install the [Web Camera Driver] (P81) and
connect the USB cable again.
In the following cases, the Web camera driver has not been installed properly.
≥ When an exclamation [!] mark appears at [USB composite device] under [USB (Universal
Serial Bus) controller] or at [USB video device] under [Imaging device]
≥ When [Web Camera] is displayed at [Other devices]
Remove the driver from Device Manager, uninstall it (P89), re-install [Web Camera
Driver] (P81), then conduct the connection procedure once more.
VQT0X39ENG.book 91 ページ ２００６年６月１４日 水曜日 午前１０時５１分