Test and Measurement
setup for measuring the output voltages of the inverter circuit. The
e tube can be measured with a dual-channel oscilloscope and two
w-capacitance (< 2.5 pf) scope probes. The oscilloscope should be connected
.
s.
Channel A should be added to the inverse
waveform on the oscilloscope.
Output waveform
This is what the typical output current waveform should look like as viewed in the above
test arrangement.
This is a basic test
output voltage to th
lo
differentially, with the probe grounds connected and floating as depicted in the diagram
Figure 7 indicates how an oscilloscope can be used for achieving these measurement
Figure 34
of channel B to produce the complete
48
Figure 35
To Next Page
Loading...
