Yes
No
Is the
BT30V
source
OK?
Check for the BT30V, DTV_9V, and
SUB_5V on connector AP3
of the AP board. Refer to Slide 45 for test
point locations.
Check the cathode of D7601
on the AP Board. Cathode of D7601
should measure 30V. If not, repair the DTV9V
DC/DC converter.
Yes
Are DTV 9V
And SUB
5V OK?
Replace defective Regulator and
biasing components. Reference
the power distribution diagram on
Slide 21.
No
Yes
Is there picture from
any of the inputs?
Are
SUB_3.3V
SUB_1.2V
OK?
Replace the A board
No
Replace the DT board
Yes
See the
troubleshooting
flowchart for No
picture.
No
No Picture
54
To Next Page
Loading...
