Panasonic th-42lf80w - Screensaver (for Preventing Image Retention)

English
46
Screensaver
(For preventing image retention)
Do not display a still picture, especially in 4:3 mode, for
any length of ime.
If the display must remain on, a Screensaver should be
used.
Screensaver
Start
10:00
Mode Off
THURSDAY 2015/01/01
■ Screensaver settings
Screensaver operation
When the Screensaver is opera ing, the following 5
patterns are displayed full screen for 5 seconds each,
and it will be repeated.
Black→ Dark grey → Grey → Light grey → White →
Light grey → Grey → Dark grey
To start Screensaver now
Select [On] in [Mode].
Select [Start] and press <ENTER>.
●
The menu screen will disappear and the
Screensaver will be activated.
Screensaver
Start
10:00
Mode On
THURSDAY 2015/01/01
Note
●
If he following buttons are pressed while the screen
saver is operating, the screen saver is cancelled.
Remote control: <RETURN>
Main unit: <MENU (Unit)> <INPUT> <+ (Unit)>
<- (Unit)>
<ENTER (Unit)>
●
When the display is turned off, the Screensaver will
be deactivated.
To set interval of Screensaver
Select [Interval] in [Mode].
Set [Periodic time].
●
Press
to change the time by 15 minutes.
Set [Opera ing time].
●
Press
once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
Periodic time
Deactivated. Operating time
Screensaver
Start
Mode Interval
Periodic time
Operating time
0:00
0:00
THURSDAY 2015/01/01 10:00
Note
●
It is not possible to set the duration of [Operating
time] longer than hat of [Periodic time].
To set start and finish time of Screensaver
Select [Time designa ion] in [Mode].
Set [Start time] and [Finish time].
●
Press
once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
Screensaver
Start
10:00
Mode Time designation
Start time
Finish time
0:00
0:00
THURSDAY 2015/01/01
Note
●
Please set [Date and time] before setting [Start
time] and [Finish time]. (see page 51)
To turn the power off after Screensaver
Select [Standby after SCR saver] in [Mode].
Set [Screensaver duration].
●
Press
once to change the time by 1 minute.
Keep pressing down to change the time by 15
minutes.
Select [Start] and press <ENTER>.
●
Screensaver will be activated and the power will
be turned off (Standby) at the time set.
Screensaver
Start
10:00
Mode
Standby after SCR saver
Screensaver duration 0:00
THURSDAY 2015/01/01
Note
●
[Screensaver duration] can be set from 0:00 to
23:59.
When this is set to [0:00], [Standby after SCR
saver] will not be activated.