8 Self Check
1. Self-Check is used to automatically check the bus lines and hexadecimal code of the TV set.
2. To get into the Self -Check mode press the Down (
) button on the customer controls at the front of the set, at the same
time pressing the Status button on the remote control, and the screen will show :
If the CCU ports have been checked and found to be incorrect or not located then “--” will appear in place of “O.K.”.
Display Ref.No Description P.C.B.
MEM IC1107 EEPROM DG-Board
GC4P IC4026 Global Core for Main DG-Board
HAD IC4012 OSD RGB A/D DG-Board
AVSW1 IC2105 Video SW H-Board
AVSW2 IC3005 Audio SW H-Board
Tun1 TU001 Tuner TA-Board
Tun2 TU8001 Tuner XV-Board
VIF - - -
DAC1 IC1106 Ext. DAC DG-Board
DAC3 IC3006 Ext. DAC H-Board
MSP IC2106 Multi Sound Processor H-Board
SOUND IC2300 Sound Control Z-Board
PANEL - Panel -
IPC IC8013 HDSL PEAKS Lite XV-Board
ADV IC4005 10bit A/D DG-Board
20
TH-42PA50E / TH-42PE50B / TH-37PA50E / TH-37PE50B
To Next Page
Loading...
