7 Disassembly
·
To disassemble P.C.B., wait for 1 minute after power was
off for discharge from electrolysis capacitors.
·
and marks indicate screw positions.
7.1. Removal of the Back Cover
1. Remove the screws (×16 ,×6 ,×4 ) and then remove
the Back Cover.
7.2. Removal of the HU-Board
1. Remove the 4 screws(A) and then remove the HU Terminal
Block.
2. Remove the 4 screws(B).
3. Remove the 3 screws(C) and then remove the HU-Board.
7.3. Removal of the HA-Board
1. Remove the 4 screws(D) and then remove the HA Terminal
Block.
2. Remove the 4 screws(E).
3. Remove the 2 screws(F) and then remove the HA-Board.
7.4. Removal of the Slot Block
1. Disconnect the couplers (J1, J2, J3, J4, J5, J6, J7, J8, J10,
J15).
2. Remove the 4 screws and then remove the Slot Block.
10
TH-42PS9UK
To Next Page
Loading...
