Option Menu for GP9D series
GP9D chassis series have special function and operation setting facility called Option Menu. This Option Menu is useful for
special function required customers. This should be set at the installation stage.
Option menus default setting Contents
Off-timer function Enable Off-timer operation Enable/Disable.
Onscreen display On Enable/Disable to display input mode indication after power on and no signal
indication.
Initial INPUT Off Sets the initial input mode when the power is turned on. Allow input mode
selection while power is on.
Initial VOL level Off Sets the initial volume level when the power is turned on. Allow Volume
control while power is on.
Maximum VOL Level Off Sets the maximum volume to desired level. Volume cannot exceed this level.
INPUT lock Off Fixes the input mode to AV, Component/RGB or PC. Can not change input
mode by input selection key.
Studio W/B Off Set warm mode color temperature to 3,200 Kelvin.
Advanced PIP Off Off: Sets normal two screen display mode.
On: Sets Advanced PIP mode.
Display size Off Adjusts the image display size on screen.
On: Sets the image display size approximately 95% of the normal image
display.
Button lock Off Enable/Disable bottom operation buttons (Input, Menu, Enter and/or volume
up/down)
Remocon User Level Off Remote key invalidation.
Off: Valid key is all key of remote.
User1: Valid key are only Stand-by (ON/OFF), Input, Direct input, Status,
Surround, Sound mute On/Off, and volume adjustment.
User2: Valid key is only Stand-by (ON/OFF).
User3: All keys are null and void
ID select 0 Set ID number from 0 to 100.
Remote ID Off Remote ID function On/Off.
(While the Remote ID on, standard remote function can not control the unit.)
Serial ID Off Serial ID function On/Off
Slot power Off Sets the slot power mode while the power is turned on.
Allow Optional Terminal Board insert Slots while power is on.
V. Installation Off V. Installation function On/Off (Not used)
Rotate Off The image rotates 180 degrees (up-down)
Serial Slot Select Slot1 Selects the slot which communicates serial.
Note: The setting of an external command can be set only from the fixed
serial terminal.
Note:
When both main unit buttons and remote control are disabled due to the “Button lock”, “Remocon User level” or “RemoteID”
adjustments, set all the values “Off” so that all the buttons are enabled again.
Press the “Volume down” button on main unit together with “R“ button on the remote control and hold for more than 5 seconds.
The “SHIPPING” menu is displayed and the lock is released when it disappears.
37
TH-42PS9UK
To Next Page
Loading...
