2. Disconnect the relay connector L, R.
3. Remove the Speaker L, R.
6.22. Remove the stand brackets.
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered), with the
plasma panel surface facing downward.
Spread a soft cloth or similar on the table for protection, so
the panel surface is not scratched.
2. Remove the stand bracket fastening screw (×6
,×8
).
6.23. Remove the C3-Board
1. Remove the flexible cable holder fastening screws (×8), and
disconnect the flexible cables (CB5, CB6, CB7 and CB8).
2. Disconnect the couplers (C33 and C32), and disconnect the
flexible cables (C31).
3. Remove the screws (×3
), and remove the C3-Board.
6.24. Remove the C4-Board
1. Remove the flexible cable holder fastening screws (×8 )
and disconnect the flexible cables (CB1, CB2, CB3 and
CB4).
2. Disconnect the coupler (C43) and disconnect the flexible
cables (C41).
3. Remove the screws (×3
), and remove the C4-Board.
16
TH-42PV500A / TH-42PV500H / TH-42PV500M
To Next Page
Loading...
