39
English
OFF TIMER
The Display can be preset to switch to stand-by after a
fixed period. (30 min, 60 min, 90 min)
The setting switches each time <OFF TIMER> is
pressed.
●
[0 min]→[30 min]→[60 min]→[90 min]
→[0 min] (Cancel)
●
When three minutes remain, the remaining time will
flash (Red). After that, it switches to stand-by.
●
To see the Off timer remaining time, press
<RECALL>.
●
The Off timer is cancelled if a power interruption
occurs. When the power is turned on later on, it will
be in stand-by condition.
Note
●
The Off timer may not operate depending on the
status, such as when the OpenPort PLATFORM
system is restarting.
To Next Page
Loading...
