3. Disconnect the connector (SS24).
4. Disconnect the Flexible Cable (SS57).
5. Remove each 2 screws and then remove the SS2-Board
and the SS3-Board.
6.13. Removal of the SS-Board
1. Disconnect the connectors (SS11, SS12, SS21, SS22,
SS33, SS34, SS35).
2. Remove the Flexible Cable from the connectors (SS53,
SS54, SS55, SS56).
3. Remove 7 screws and then remove the SS-Board.
6.14. Removal of the stand blocks
1. Remove the plasma panel section from the servicing stand
and lay on a flat surface such as a table (covered) with the
plasma panel surface facing downward.
2. Remove the stand blocks (left, right) fastening screws (x 4
each) and remove the stand blocks (left, right).
12
TH-50PH10BK / TH-50PH10BS / TH-50PH10EK / TH-50PH10ES
To Next Page
Loading...
