Panasonic TH-P50VT20D - 8.24. Remove the Plasma Panel Section; 8.26. Remove the K-Board; 8.27. Remove the V-Board

29
8.24. Remove the Plasma panel sec-
tion from the Cabinet assy
1. Remove the Cabinet mount metals fastening screws (×10
).
2. Remove the plasma panel fastening screws (×3 , ×8
) and remove the cabinet assy.
3. For leaving the cabinet assy from the plasma panel, pull
the bottom of the cabinet assy forward, lift, and remove.
8.25. Remove the Contact metals
1. Remove the Cabinet assy. (See section 8.24.)
2. Remove the screws (×4 ).
3. Remove the Contact metal top.
4. Remove the screws (×6 ).
5. Remove the Contact metal bottom.
6. Remove the screws (×4 ).
7. Remove the Contact metal side (L, R).
8.26. Remove the K-Board
1. Remove the Contact metal bottom. (See section 8.25.)
2. Remove the screw (×1 ).
3. Remove the claw (×1 ).
4. Disconnect the connector (K1) and Remove the K-Board
from LED Panel.
8.27. Remove the V-Board
1. Remove the Contact metal bottom. (See section 8.25.)
2. Remove the screw (×1 each).
3. Disconnect the connector (V1 each) and Remove the V-
Board from the Emitter fixing metal.