30
8.28. Replace the plasma panel
Caution:
A new plasma panel itself without Hanger metals is
fragile.
To avoid the damage to new plasma panel, carry a new
plasma panel taking hold of the Hanger metals after
assembling the Hanger metals and the One leg bracket.
1. Place a carton box packed a new plasma panel on the flat
surface of the work bench.
2. Open a box and without taking a new plasma panel;
Attach the C1, C2, C3, C4, C5 and the C6-Board, connect
the flexible cables from the plasma panel to the C1, C2,
C3, C4, C5 and the C6-Board, and fit the flexible cable
holders.
3. Attach the Hanger metals and the One leg bracket to the
new plasma panel.
4. Place the plasma panel on the servicing stand taking hold
of the Hanger metals.
5. Attach the cabinet assy and each P.C.Board and so on, to
the new plasma panel.
To Next Page
Loading...
