29
Your new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scart connection is
preferable if the VCR is so equipped (see page 37 for suitable inputs to each of the Scart sockets on this TV).
However, if for some reason your VCR is tuned to a different RF channel then you willnot receive any picture or sound from your VCR
on programme position ‘0’ of the TV. Either adjust the tuning of the TV’s programme position ‘0’ (follow the instructions below) or adjust
the RF channel of your VCR (some VCRs allow adjustment of their RF channel via their remote control unit) or both untilthe TV receives
the RF output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Tuning your TV to the VCR
Switchon theVCR,insert andplayapre
--
recordedtape with
known content
Press the
SETUP
menu button
Move to
Tuning menu
option
Access
Tuning menu
Move to
Manual tuning
Access
Manual tuning
Select programme position ‘0’ VCR
Start searching for the VCR playback
of the known content tape
When the VCR playback is found,
press
STR
to store
Press the
TV/AV
button to exit
Notes:
D
If picture patterning occurs on programme position
‘0’ it may be necessary to adjust the RF output
channelof theVCR,refer totheVCR instructionbook.
D
If a SatelliteReceiver and a VCR aregoing to be used
with RF cable connections it is important to avoid
both units being set on the same channel.
Refer to the Satellite Receiver and VCR instruction
books for precise tuning information.
Tuning your VCR and satellite receiver
VCR
The tapewith known content isfound and displayed.
Pressing
STR
will store the setting.
SET UP
STR
TV/AV
To Next Page
Loading...
