- 40 -
1. Select the forthcoming programme or channel with / / / and
press OK to access
2. Select USB HDD Rec. / Reminder with
/ and press OK to set
●
To check / change / cancel a timer programming event
Recording Timer Programming Editing timer programming
●
LED will turn to orange in Standby mode if Timer Programming is set.
●
To return to TV Guide
BACK/RETURN
●
If you select the current programme, a confirmation screen asking
whether you want to watch or record the programme appears. Select
Timer Programming with / and press OK to set USB HDD Rec. to
record from the time you finish the timer programming event setting.
●
Depending on the country you select, you can set Signal Supported
Recording (see below).
= Note =
●
Not valid in Analogue mode
●
Timer Programming only works reliably if correct time information is
received via the signal from the broadcaster or service provider.
●
No other channels can be selected while the recording of Timer
Programming is in progress.
●
When recording programmes to the USB HDD, be sure to format the USB
HDD and enable it to record in USB Device Setup.
Recording USB HDD setup
■ Signal Supported Recording (Timer Programming from the
TV Guide signal)
Signal Supported Recording is Timer Programming which is controlled by
information from the TV Guide; if programme start and end times are changed
by the broadcaster, the timer programming event will follow the change. Note
that Signal Supported Recording only works reliably if correct information is
received from broadcasters.
●
The availability of this function depends on the country and TV mode you
select.
●
is displayed on the Timer Programming screen if Signal Supported
Recording is set.
= Note =
●
If you edit the start time or end time of a signal supported recording event
by more than 10 minutes, it will no longer follow the broadcaster’s changes
To Next Page
Loading...
