- 88 -
with / / / and press OK to access
3. Select Connect to device in WPS with
/ and press OK to access
●
To set manually, select Change settings. (see below)
4. Select and set WPS(Push button) / WPS(PIN) with
/ and press OK to
access
WPS(Push button):
Set the equipment to WPS (Push button) mode. For details, read the
manual of the equipment.
WPS(PIN):
Enter the PIN code of the equipment.
●
If the connection has failed, check the settings and positions of the
equipment. And then, follow the on-screen instructions.
■ Change settings
You can set up Network name(SSID), Encryption key, Wireless type and
Channel setting method manually.
Follow the on-screen instructions and set manually.
●
Set Reset settings to reset the items of Change settings.
= Note =
●
You cannot connect the internet service while the TV is set to Wireless
Access Point.
●
You can connect up to 7 devices. But the transfer rate will vary according
to communication environment or the numbers of connected equipment.
●
To confirm the current network settings
Home network Network settings Network Status
●
Ensure the equipment to connect supports WPS for this setup.
●
WPS: Wi-Fi Protected Setup™
Network Status
Displays and checks the network status (MAC Address, current network
settings, etc.).
1. Display the menu with MENU
2. Select Network
Network Status with / and press OK to access
3. Automatically testing is done and the Network Status screen is displayed
Try Again:
Performs automatic testing of the network connection for the TV and
displays the current status again.
To Next Page
Loading...
