Panasonic UF-7300 - Service Modes; Service Modes (For Copier)

152
UF-7300/7200
UF-8300/8200
5 Service Modes
5.1. Service Modes (For Copier)
These Service Modes are provided to assist the technician in checking for abnormalities in the copier and a
means of making adjustments to the Input/Output of major components.
Caution:
The factory default parameters are preset (country dependent) for optimum performance and in
compliance with the local telecommunication regulations/standards, and do not need to be changed.
Changing some of these parameters may cause the unit to be no longer compliant or become inoperable.
5.1.1. Service Mode Procedure
1. To select the Service Mode
The service mode is selected when the “Function”, “Original Size” and the “3” keys are sequentially
pressed, Input the ID to enter the Service Mode (default ID is 00000000) and press the “Set” key, then
F1 will appear in the display.
2. To exit the Service Mode
The service mode is reset when the “Function” and the “Clear” keys are pressed sequentially.
5.1.2. Copier Service Mode Functions
Service Modes (For Copier)
Service
Mode
Item Function
F1 SELF TEST 00 SCANNER LED TEST This test is used for checking the Scanner LED.
01 LCD/LED TEST This test is used for checking the LCD and
LEDs.
02 PAGE MEMORY TEST This test is used for checking the Page Memory.
03 PRT TEST PTN. 1 Prints the pattern for setting the Paper position
alignment.
04 PRT TEST PTN. 2 Prints the Slant pattern for setting the Paper
position alignment.
05 PRT TEST PTN. 3 Prints the Grid pattern for setting the Paper
position alignment.
F2 SINGLE COPY TEST One sheet is copied when the Start key is
pressed.
F3 CONTI. CPYTEST Multi copies are made when the Start key is
pressed.
F4 I / O STATUS TEST The functioning of Input / Output items (selected
item numbers) is checked.
F5 FUNC. PARAMETERS Various function settings (selected by code
numbers) can be changed.
F6 ADJ. PARAMETERS Various function settings (selected by code
numbers) can be adjusted.
F7 ELECTRONIC COUNTER Electronic Counters for Maintenance
F8 SERVICE ADJ. Perform pseudo-operation of an item (selected
by code numbers)
F9 UNIT MAINTENANCE Fax Service Mode
Service Alert Tel #
Firmware Version
Print Device Info.