24
Using the Unit
{PUSH} mode (Push to talk mode)
1 When a call is received from the door station, press {TALK}.
2 Speak to the visitor.
3 To end the conversation, press {TALK}.
L The display will turn off.
{AUTO} mode (Auto talk mode)
This mode allows you to answer the call by voice. Speak a brief reply into (or toward) the
monitor station, such as “Yes?” or “Hello?”. This reply is used to start {AUTO} mode; the
visitor will not hear your reply. The monitor station will beep to indicate {AUTO} mode has
started and you may then speak to the visitor.
1 When a call is received from the door station, answer “Yes?” within 30 seconds.
L A beep will sound to indicate that you can talk to the visitor (hands-free conversation).
2 Speak to the visitor.
3 To end the conversation, press {TALK}.
Note:
L Make sure you are within about 50 cm (20 inches) of the monitor station.
L You can also answer the call by pressing {TALK}.
L Your initial reply should be brief (less than 1 second), otherwise {AUTO} mode will not start.
L If a visitor calls you, a loud, brief sound (such as a barking dog) may start {AUTO} mode
even though you have not replied by voice.
{HOLD} mode (Hold to talk mode)
1 When a call is received from the door station, press and hold {TALK} to speak to the caller.
L A beep will sound and the Talk indicator will light.
2 To listen to the visitor, release {TALK}.
L The Talk indicator will turn off.
3 To speak again, press and hold {TALK}.
4 To end the conversation, tap {TALK}.
Note:
L Make sure you speak to the caller only while pressing {TALK} and release {TALK} when
you have stopped speaking so that the caller can speak to you.
GM201A.book Page 24 Monday, April 4, 2005 5:10 PM
To Next Page
Loading...
