Panasonic VL-MV26 - Operations; Answering Calls

4.1 Displays
Image viewing screen
1
1
2
CAMERA
Status icons (page 7)
Soft key icons (page 6)
Status icons
1
Indicates which lobby is calling,
monitoring, or on a call.
("1" indicates the device number.)
1
Indicates which camera is monitoring.
("1" indicates the device number.)
Indicates that the main monitor is talking.
Indicates that the main monitor is
monitoring.
Indicates that images are being recorded
(page 8).
Indicates that "Press-to-talk" mode is on
(page 7).
Indicates that the lobby station’s LED lights
are on (page 9).
Settings screen
The settings screen is used to access and set the various
settings of the main unit. For information on available
settings see page 11.
Information screen
The information screen is used to display information
such as the current status of the main monitor.
R Information is not updated while it is displayed.
4.2 Answering calls
4.2.1 Answering lobby station calls
When you receive a call from a lobby station, the main
monitor rings, and displays an image from the lobby
station.
To answer the call
Press M
/OFF
N.
R Speak within about 50 cm of the microphone.
R Speak alternatively with the visitor. If you and the
visitor speak at the same time, you will not hear each
other.
R Calls are disconnected after the pre-programmed
"timeout" time elapses.
To end the call
Press M
/OFF
N.
Note:
R The displayed image is automatically recorded to the
main monitor (page 8).
Features available during incoming calls
– Monitoring feature (page 8)
Features available while talking
– Turn on or off the operation guide (page 9)
– Adjusting sound and display settings (page 9)
– Using "press-to-talk" (page 7)
4.2.2 Answering extension telephone calls
When you receive a call from an extension telephone,
the main monitor rings and displays the name of the
extension telephone.
1 Press M
/OFF
N.
2 When finished, press M
/OFF
N.
Features available while talking
– Adjusting sound settings (page 9)
– Using "press-to-talk" (page 7)
4.2.3 Press-to-talk mode
If it is difficult for you and the visitor to hear each other
due to noise, the "press-to-talk" mode can make
conversations easier to hear.
1 While talking, activate press-to-talk mode by
pressing and holding M
/OFF
N for about
2 seconds.
R A beep sounds and
is displayed.
2 To speak to the visitor
Speak while pressing and holding M
/OFF
N.
To listen to the visitor
Release M
/OFF
N.
7
4. . Operations
4. Operations