EasyManua.ls Logo

Panasonic VL-MWD501 - 1-1. Comparison

Panasonic VL-MWD501
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Others
R It is prohibited to disassemble or modify this product.
Contact the dealer where you purchased this product
for repair.
Battery installation
USE ONLY rechargeable Ni-MH batteries AAA (R03)
size.
Do NOT use Alkaline/Manganese/Ni-Cd batteries.
Confirm correct polarities (
, ).
Note:
R Use the supplied rechargeable batteries (Ni-MH
ONLY). For replacement, we recommend using the
Panasonic rechargeable batteries noted on the
Operating Instructions of the Video Intercom System.
R Wipe the ends of batteries (
, ) with a dry cloth.
R Avoid touching the ends of batteries ( , ) or the
unit contacts.
Charging the sub monitor
Only connect the charger with the supplied Panasonic
AC adaptor (® page 2).
AC adaptor connections
A
*1
B
*1 Press plug firmly.
R Connect the charger to the power outlet, and then
place the sub monitor in the charger to charge it.
Charging usually takes about 8 hours.
A Charge indicator
when charging: lights
when charging is completed: off
B Hook
R Charge the sub monitor for at least 15 minutes before
registering it to the main monitor. Make sure to
completely charge the sub monitor after the
registration is completed.
R Charging may take longer in the following situations.
When the operating temperature is low. (®
page 6)
When the sub monitor is picked up off the charger
or used during charging.
When the sub monitor’s signal is out of range
(
).
R The sub monitor does not overcharge even if it is
continuously placed in the charger.
Battery level
Icon Battery level
High
Medium
Low
Needs charging
R See page 6 for a guide on operating times for the
sub monitor.
Note:
R When the sub monitor is off the charger or the AC
adaptor is disconnected for 1 week or more, remove
the batteries in order to maintain battery performance
and prevent the batteries from discharging.
Recharge the batteries before using the sub
monitor again.
Wall mounting
Note:
R Make sure that the wall and the fixing method are
strong enough to support the weight of the unit.
R Drive the screws (locally procured) into the wall.
25 mm
5

Other manuals for Panasonic VL-MWD501

Related product manuals