Copier Settings: Changing the Initial Copy Modes
● Default function of each copy mode.
(See pages 49 and 50)
For Key Operator:
Original mode, Contrast, etc.
(See pages 50 and 51)
Printer Settings: Changing the Initial Printer Modes
● Default function of each print mode.
(See page 51)
For Key Operator:
Job completion time, Page protection, Error page print,
Spool function, PS configuration, Font list print, Mailbox
data handling, etc.
(See page 52)
● Normally, you do not need to set the Printer Settings.
Special Printer Settings may be required when printing
text data directly to the printer from the MS-DOS
command prompt.
Scanner Settings: Changing the Initial Scanner Modes
● Original mode, Compression mode, Resolution, etc.
(See page 53)
Fax/Email Settings: Changing the Initial Fax/Email Modes
Refer to Operating Instructions (For Facsimile & Internet
Fax/Email).
3 4
Setting the desired Function
Parameter(s).
Select a setting with the
Keypad.
Confirm a setting with the
SET Key.
Select a mode with the Cursor Key or
Keypad
When selecting the Key Operator Mode:
(Ex: General Settings)
5
5
4 6
09 KEY OPERATOR MODE
ENTER PASSWORD=_
Input the Key
Operator
Password
(3-digit)
(See page 13)
Set the desired Function Parameter(s).
Select a mode with the Cursor Key or
Keypad.
Select a setting with the Keypad.
Confirm a setting with the SET Key.
or
3
Exits this
Function
Mode
Exits this
Function
Mode
To Next Page
Loading...
