17
Step 1
Install the mount bracket.
• Refer to "Mounting the Camera" (page 15).
Step 2
Insert a mini SD memory card into the mini SD memory
card slot.
• Refer to page 21 for how to insert a mini SD memo-
ry card.
Step 3
Connect the cables.
• Refer to page 18 for how to connect the cables.
Step 4
Mount the camera onto the mount bracket.
1. Mount the camera onto the housing attachment
base and fix them with the screws at 3 places
2. Attach the provided watertight caps onto the screw
heads.
Step 5
Attach the provided front/rear sun shields to the cam-
era.
1. Hold the concave portions of the front/rear sun
shields with your fingers and disassemble it by
releasing the stoppers.
The front/rear sun shields are connected by the
wire to prevent losing one of them.
2. Position the front/rear sun shields to tuck down the
housing attachment base.
3. Attach the front/rear sun shields together.
Fit up the stopper on the wired side first, and then
fit up the stopper on the other side.
Safety wire
Sun shield
Front/rear sun shield
Installation
Before starting installation/connection, make sure that the power cable is not connected to an outlet.
Read the "Precautions for installation" section before starting installation/connection. (☞ page 13)
Fixing screw
Housing attachment base
Watertight cap
(provided)
Release the stoppers
Concave portion
Wire
Housing attachment base
Front/rear sun shield
To Next Page
Loading...
