Panasonic WV-SC385PJ - Page 90

• H.264: H.264 will be set for the video encoding format. The subsequent setting items will be for H.264.
(®page 82) The tab name will be changed to [JPEG/H.264].
• MPEG-4: MPEG-4 will be set for the video encoding format. The subsequent setting items will be for
MPEG-4.
The tab name will be changed to [JPEG/MPEG-4].
• Default: H.264
MPEG-4(1) / MPEG-4(2)
[MPEG-4 transmission]
Select “On” or “Off” to determine whether or not to transmit MPEG-4 images.
• On: Transmits MPEG-4 images.
• Off: Does not transmit MPEG-4 images.
• Default: On
IMPORTANT
• When “4:3 (800x600)”
*1
or “16:9” is selected for “Aspect ratio”, MPEG-4 transmission is unavailable.
• When “H.264” is selected for “Recording format”, MPEG-4 transmission is unavailable.
Note
• When “On” is selected for “MPEG-4 transmission” in “MPEG-4(1)” or “MPEG-4(2)”, displaying of
MPEG-4 images or JPEG images on the “Live” page will be available.
• When “On” is selected for “MPEG-4 transmission” in “MPEG-4(1)” and “MPEG-4(2)”, MPEG-4 images
are viewable using other devices with each setting.
• When “On” is selected for “MPEG-4 transmission” in “MPEG-4(1)” or “MPEG-4(2)”, the transmission
interval of JPEG images may be longer.
[Internet mode (over HTTP)]
Select “On” when transmitting MPEG-4 images via the Internet. It is possible to transmit MPEG-4 images
without changing the broadband router settings configured for JPEG image transmission.
• On: MPEG-4 images and audio will be transmitted using the HTTP port. Refer to page 169 for further
information about the HTTP port number settings.
• Off: MPEG-4 images and audio will be transmitted using the UDP port.
• Default: Off
Note
• When “On” is selected, only “Unicast port (AUTO)” will be available for “Transmission type”.
• When “On” is selected, it may take seconds to start displaying MPEG-4 images.
• When “On” is selected, MPEG-4 images may not be displayed depending on the number of the
concurrent access users and audio data availability, etc.
• When “On” is selected, only IPv4 access is available.
[Image capture size]
Select “QVGA” or “VGA” for the image capture size of MPEG-4 images.
• Default:
– MPEG-4(1): VGA
– MPEG-4(2): VGA
[Transmission priority]
Select a transmission priority for MPEG-4 images from the following.
• Constant bit rate: MPEG-4 images will be transmitted with the bit rate selected for “Max bit rate (per
client)*”.
90 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]