11
Periodically images on the screen appear
to be distorted
When the camera is installed in a location
where it is subject to small vibrations (for exam-
ple, when it is installed near devices that
vibrate), images may appear distorted and
stretched lengthways. This phenomenon is a
characteristic of image pickup devices that use
MOS sensors and is caused by the relationship
between the periodic movements of the cam-
era and the timing that the image sensor reads
images. This is not a problem with the camera.
To reduce the possibility of this phenomenon
occurring, install the camera in a secure loca-
tion.
About SD memory card
• To remove the SD memory card from the
unit, press the [Set] button on the “Live”
page, select the [SD memory card] tab,
and set the SD memory card operation to
“Not use”. Then, remove the SD memory
card.
• When using an SD memory card, format it
using this product. Recorded data on the
SD memory card will be deleted when for-
matted. If an unformatted SD memory card
or an SD memory card formatted with
other devices is used, this product may
not work properly or performance deterio-
ration may be caused. Refer to the
operating instructions on the provided
CD-ROM for how to format an SD memory
card.
• When some SD memory cards are used
with this product, the product may not
work properly or performance deterioration
may be caused. Use the compatible SD
memory cards. (
☞ page 36)
• When using an SD memory card
supporting Class 10 of the speed class,
use a UHS-I (Ultra High Speed-I) compliant
card.
We shall not be liable for content
compensation, losses of recorded or
edited content and any direct or indirect
consequent damages caused by failure to
record or edit due to faults with this unit or
the SD memory card. In addition, the same
provisions apply after unit is reparied.
Operating temperature
Only turn the power on for the camera when
the temperature is -30°C {-22 °F} or warmer.
This product can be used in low temperature
outdoor environments that get as cold as
–40°C {-40°F}. However, when this product is
installed and operated in temperatures below
–30°C {-22°F}, normal images may not be
obtained immediately after startup.
What to do if “WARMING UP-PLEASE
WAIT” appears on the display.
This message indicates that the temperature
inside the camera has become extremely low.
Wait until the internal temperature of the cam-
era rises (for around 2 hours or more in tem-
peratures below -30 ºC {-22 °F}), turn the
power off once, then turn it back on again.
About the MOS image sensor
• When continuously shooting a bright light
source such as a spotlight, the color filter
of the MOS image sensor may become
deteriorated and this may cause discolor-
ation. Even when changing the fixed
shooting direction after continuously
shooting a spotlight for a certain period,
the discoloration may remain.
• When shooting fast-moving subjects or
objects crossing the shooting area may
look to be bending askew.
About the built-in microphone
• If moisture attach to the peristome of built-
in microphone, the volume may decrease.
Please leave it to air dry sufficiently before
use.
• When cleaning the peristome of built-in
microphone, do not use any sharp-ended
object to stab it. Doing so may result in
failure or submerging.
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury. Do not
use benzine, thinner, alcohol, or any other
types of solvents or detergents. Otherwise, it
may cause
discoloration. When using a chemi-
cal cloth for cleaning, read the caution provid-
ed with the chemical cloth product.
To Next Page
Loading...
