[Audio encoding format]
Select the audio reception encoding format from G.726, G.711, and AAC-LC.
• Default: G.726
Note
• G.711 is available only when “Mic input” is selected for “Audio transmission/reception”.
• G.726 is always applied for the audio transmission encoding format.
[Audio bit rate]
Select “16kbps” or “32kbps” for the audio bit rate used to transmit/receive audio data.
• Default: 32kbps
Note
• When selecting a smaller value for “Bandwidth control(bit rate)” (®page 139) while putting a priority
on the JPEG image transmission, select “16kbps” for “Audio bit rate”.
• [Audio bit rate] is unavailable when “G.711” or “AAC-LC” is selected for “Audio encoding format”.
[Mic input volume (Camera to PC)]
Select a volume level on the PC to hear audio transmitted from the camera.
• Mic High
: The volume level will become high. This setting will be applied when audio
is input to the camera using a microphone.
• Mic Middle
: The volume level will become middle. This setting will be applied when
audio is input to the camera using a microphone.
• Mic Low
: The volume level will become low. This setting will be applied when audio is
input to the camera using a microphone.
• Line High
: The volume level will become high. This setting will be applied when audio is input
to the camera using the Line input.
• Line Middle
: The volume level will become middle. This setting will be applied when audio is
input to the camera using the Line input.
• Line Low
: The volume level will become low. This setting will be applied when audio is input to
the camera using the Line input.
• Default: Mic Middle
Note
• These settings are linked with the volume settings of “Audio recording” and “Audio detection”.
[Mic input interval (Camera to PC)]
Select an interval for audio reception from the following.
20ms/ 40ms/ 80ms/ 160ms
• Default: 40ms
Note
• When a shorter interval is selected, the delay time will be shorter. When a longer interval is selected,
audio interruption may be diminished even though the delay time will be longer. Select the interval
according to the network environment.
• “Mic input interval (Camera to PC)” is unavailable when “AAC-LC” is selected for “Audio encoding
format”.
[Audio output volume (PC to Camera)]
Select a volume level on the camera to hear audio transmitted from the PC.
High/ Middle/ Low
• Default: Middle
Operating Instructions 107
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
