Panasonic WV-SW598

Specifications
• Basic
WV-SW598 WV-SW397
Power source: AC 24 V, PoE+ device (IEEE802.3at compliant) or Tested PoE injector (60 W)
Power consumption *
1
: AC 24 V: 3.5 A/Approx. 55 W
Tested Power over Ethernet (Injector: 60 W) DC 54 V: 1.0 A/Approx. 50 W
PoE+ DC 54 V: 470 mA/Approx. 25 W (Class4 device)
Ambient operating temperature:
–50 °C to +55 °C {–58 °F to +131 °F} (AC 24 V/ Tested PoE injector (60 W)) *
2
–30 °C to +55 °C {–22 °F to +131 °F} (PoE+ device)
(Power On range: –30 °C to +55 °C {–22 °F to +131 °F}
(AC 24 V/ PoE+ device/ Tested PoE injector (60 W)))
Ambient operating humidity:
Less than 90 % (no condensation)
Storage environment
Storage temperature: –50 °C to +70 °C {–58 °F to +158 °F}
Storage humidity:
Less than 95 % (no condensation)
Monitor output (for adjustment):
VBS:1.0V[p-p]/75Ω,composite(BNC)
External I/O terminals: ALARM IN 1 (DAY/NIGHT IN)/ ALARM IN 2 (ALARM OUT)/
ALARM IN 3 (AUX OUT) (x1 each)
DAY/NIGHT IN, ALARM OUT, and AUX OUT can be used by changing the settings
of Terminal 1, Terminal 2, and Terminal 3.
Microphone/line input: ø3.5 mm monaural mini jack
Inputimpedance:Approx.2kΩ(unbalanced)
For microphone input: Applicable microphone: Plug-in power type
Supplyvoltage:2.5V±0.5V
Recommendedsensitivityofmicrophone:-48dB±3dB(0dB=1V/Pa,1kHz)
For line input: Input level: Approx. –10 dBV
Audio output: ø3.5 mm stereo mini jack (monaural output):
Outputimpedance:Approx.600Ω(unbalanced)
External speaker with an amplifier:
Output level: -20 dBV
Water resistance *
3
: Main body: IP66 (IEC60529),Type 4X (UL50),NEMA 4X compliant
Shock resistance: Compliant with IK10 (IEC62262)
Dimensions: ø229 mm x 392 (H) mm {ø9-1/32 inches x 15-7/16 inches (H)},
diameter of the dome: 160 mm {6-5/16 inches}
Mass: Main body: Approx. 5.0 kg {11.02 lbs}
Finish: Main body: Aluminum die cast with glazed melamine coating
(Coating color: Natural silver)
Sunshields*
4
: ASA resin coating (Coating color: Natural silver)
Dome cover section:
Clear polycarbonate resin (Rain wash coating)
SW598 SW397A
Clear polycarbonate resin
SW397
*1 Refer to our website (http://security.panasonic.com/pss/security/support/info.html) for further information about Power
source and Power consumption information.
*2 When using the camera in low temperature environments, because the heater warms the camera to keep its internal
temperature above –10 °C {14 °F}, keep the power for the camera always turned on. Perform settings or startup
operations when the ambient temperature is –30 °C {–22 °F} or higher.
*3 Only when installation work is properly performed according to the instructions in this book and appropriate waterproof
treatment is performed.
*4 It is impossible to remove the main sunshield.
•
Camera
Image sensor: Approx. 1/3 type MOS image sensor
Effective pixels: Approx. 2.4 megapixels
Scanning area: 5.38 mm (H) × 3.02 mm (V) {7/32 inches (H) x 1/8 inches (V)}
Scanning system: Progressive
36