Panasonic X300 - Call Status

20 Basic Operations
End
You can select one of the calls to disconnect while in a conference call.
During a call:
1.
A(Menu)
2.
4 End A(Select)
Split
You can separate an individual from the active conference call.
During a call:
1.
A(Menu)
2.
4 Split A(Select)
Call status
Call status allows you to disconnect the line or put a call on hold with the active party.
You can also activate a call that is put on hold.
During a call:
1.
A(Menu)
2.
4 Call status A(Select)
3.
4 required active call A(Select)
4.
A(End) to disconnect the line
OR
@(Hold) to put the call on hold
• To resume,
A(Back).
• You can activate the required inactive call by pressing
A(Join) in step 3.
Swap
When you are connected to two calls, you can switch between the active call and the
held call.
During a call:
@(Swap) to switch to the other call on hold
NOTE: Split is network dependent.
