PANAFLEX MILLENNIUM
5.5 Removing the aperture plate
To remove the aperture plate, inch the camera
until the pulldown claw is at the bottom of
its stroke, disengaged from the film, with the
registration pins fully engaged.
Pull out the spring-loaded registration pin
retraction knob and pull the pins back to clear
the gate.
Turn the top lock clockwise and the bottom
thumb lock counter-clockwise. Hold the bot-
tom lock horizontally and pull to remove the
plate.
Replace the aperture plate by holding the bot-
tom lock horizontally and pushing the plate
onto the top locating pin. Push the bottom lock
down and set top lock by pulling it out and
turning it counter-clockwise.
camera operation
To Next Page
Loading...
