Pandora Elite security system is an efficient measure of anti-theft security and to prevent hijack-
ing. This system is shipped with 2 immobilizer radio tags. To increase security, 1 to 3 radio relays can be
installed on the car. Immobilizer functions can be switched on and off via a phone or using Pandora
AlarmStudio on a computer.
'Proximity detection of the owner' programmable algorithm that detects either RF tag is
approaching or distancing from the car increases precision of Hands Free function (automatic arming/
disarming on removing/approching. Immobilizer mode adjustment can be set via the remote.
Immobilizer mode
This mode is enabled by default, use a phone to disable this mode (see ‘Change settings via
phone’ section).
When the ignition is being switched on, the system base unit performs a search for immobilizer
tags in radio zone. If no tags were detected, LCD remote will play 'No tag found' ringtone. If no radio
tags were detected when the ignition is switched on, the system will block the engine with all radio
relays that were programmed into the system. Engine blocking will only occur when radio relay
motion sensor detects movement of the car. If additional blocks were installed, they will lock doors
immediately, before the car starts moving.
Antihijack mode
This mode is disabled by default, use a phone to enable this mode (see ‘Change settings via
phone’ section). Antihijack mode helps to prevent aggressive seizure of the car using delayed engine
blocking on door opening.
Every time when the engine is running on opening/closing a door, immobilizer requests response
from a remote using unique algorithm. After a door was opened while the engine is running,
if the system cannot detect a radio tag, the engine will be stopped after 1 minute (general safety
requirement). 'Engine blocking warning' ringtone will play before blocking.
If engine blocking is performed via radio relay after warning signals are over or on new attempts
to start the engine, immobilizer will only allow the engine to start when the car is not moving, and
will block it again if it starts movement. Immobilizer will be in active mode in no more than 2 seconds
after the ignition is switched on. If the car starts moving, the immobilizer will block the engine for 15
seconds. When registered tag appears in the radio zone, blocking will be canceled and the system will
return to the normal operation.
If the engine is blocked via analog relay, engine operation will be stopped after warning signals
are over, until a registered tag appears in the radio zone or on registering movement - depending on
the settings.