Event history
HISTORY
BACK
21:46 ARM
21:33 DISARM
21:15 ARM
20:55 DISARM
To access event history into the system's memory, press and hold button 6 for 2 second
. Nagivate
several last events using button 6 (forward) and button 4 (back). Events are displayed by showing
time when event happended and flashing corresponding indicators. To exit this mode, press button F,
otherwise the mode will be exited in 60 seconds.
9
9
0
0
*
*
- Listen to the extended event history using a phone.
WARNING!
ENGINE TEMPERATURE INDICATION IS AVAILABLE ONLY WHEN TEMPERATURE
SENSOR IS CONNECTED. SENSOR AVAILABILITY DEPENDS ON THE SYSTEM SET.
FUEL LEVEL INDICATION IS AVAILABLE ONLY WHEN THE SENSOR IS CONNECTED
OR THERE IS INFORMATION IN CANBUS.
Remote and automatic engine start
The system allows for remote engine start using remote engine start command or automatic
engine start using preconfigured automatic engine start function. Remote start can be used to heat
engine and interior, charge battery or cool the inerior with air conditioning.
Remote and automatic start can only be used when the system is armed.
If the car has manual transmission, remote or automatic start will only occur if programmed
neutral procedure was followed when the car was arming.
Remote and automatic engine start on automatic transmission cars will only occur, if transmission
selector lever was left in a 'P' position.
When using remote and automatic engine start functions, make sure that the car is secured with
handbrake or some other means of fixating the car on a parking position.
While system is in remote and automatic start mode, it keeps performing all security functions
save for shock sensor that will be disabled. To compensate, motion sensor sensitivity, responsiveness
To Next Page
Loading...
Need help?
General
