15
User manual
Remote engine start
If the system is prepared for remote start, to execute it, press and hold button for 3 seconds.
Sound signal will confirm the command, LCD will show flashing engine operation icon
signifying
preparation to the engine start. In a few seconds the engine will be started, the remote will play
“ENGINE START” ringtone and show spinning engine operation icon
.
3 ashes
«Engine start»
ringtone
press and hold
for 3 sec.
preparing
engine start
~~
Engine operation duration depends on system settings – either heating time or threshold
temperature for engine stop.
To remotely stop the engine while it performs heating, press and hold
button for 2 or more
seconds. The engine will be immediately stopped and it will be confirmed by the remote playing
“ENGINE STOP” ringtone and engine operation icon
fading
«Engine stop»
ringtone
press
and hold
for 2 sec.
engine stop
~~
«Engine start»
ringtone
~~
The remote will give notification 1 minute before designated engine stop: icon will flash
and “engine stop in 1 minute” ringtone will play every 10 seconds. Sending “Remote engine start”
command will extend its operation period by 10 minutes. This procedure can be repeated multiple
times.
To Next Page
Loading...
Need help?
General
