24
Security-service system Pandora Light
WIRES DESCRIPTION
Х4 Socket (main socket)
• Wire 1 (White) (Tachometer input) — Analog input of the tachometer signal, it connects to
the tachometer wire or to the signal wire of a nozzle, which provide stable pulses of any polarity
corresponding to the RPM.
• Wire 2 (Red-black) (CH5) — Factory setting is ‘Opening trunk’. A negative output of additional
channel with maximum load capacity 200mA. This output is multipurpose, it can operate in
accordance with selected logic.
• Wire 3 (Orang-white) (CAN-High) — Wire of digital bus CAN-High It connects to an appropriate
CAN-High wire of a car.
• Wire 4 (Yellow-white) (CAN2-H/CH4) — Wire of digital bus CAN2-High. It connects to an
appropriate CAN2-High wire of a car. This channel can be assigned as an output (CH4), it will not
work as a digital bus in this case.
• Wire 5 (Gray) (INP2) — Factory setting is ‘Door switches’. This wire connects to a wire that becomes
grounded when the door opens. This input is multipurpose, it can operate in accordance with
selected logic.
• Wire 6 (Green) (СН3) — Factory setting is ‘Turn indicators’. This wire connects to the hazard
flashers button. A negative output of additional channel with maximum load current 200mA. This
output is multipurpose, it can operate in accordance with selected logic.
• Wire 7 (White-blue) (INP5) — Factory setting is “Brake pedal” This wire connects to the brake
pedal button where 12V voltage appears when the pedal is pressed (stop lights wire). Brake pedal
signal is one of the system’s security zones. This input is multipurpose, it can operate in accordance
with selected logic. This input can be used as “Fuel level” input, calibration of the fuel level is
performed by the VALET button.
• Wire 8 (Black) (“Ground”) — This wire must be connected to the “Ground”. This wire must be
connected first during installation.
• Wire 9 (Blue) (INP4) — Factory setting is ‘Neutral/Handbrake’. This wire connects to an appropriate
wire of a car. This input is multipurpose, it can operate in accordance with selected logic.
• Wire 10 (Brown-white) (INP3) — Factory setting “Front hood switch”. This wire connects to an
appropriate wire that becomes grounded when the front hood opens. This input is multipurpose,
it can operate in accordance with selected logic.
• Wire 11 (Orange-black) («CAN-Low») — Wire of digital bus CAN-Low. It connects to an
appropriate CAN-Low wire of a car.
• Wire 12 (Yellow-black) (CAN2-L/CH2) — Wire of digital bus CAN2-Low. It connects to an
appropriate CAN2-Low wire of a car. This channel can be assigned as an output (CH2), it will not
work as a digital bus in this case.
To Next Page
Loading...
Need help?
General
