Pandora Light - Wiring Description - Relay Module Socket; X5 Relay Module Socket Functions

25
User manual
• Wire 13 (Blue-black) (CH1) — Factory setting is ‘Beeper’. A negative output of additional channel
with maximum load current 200mA. This output is multipurpose, it can operate in accordance with
selected logic.
• Wire 14 (Yellow) (INP6) — Factory setting is ‘Ignition’. This wire connects to ignition switch or to
an appropriate wire where 12V voltage appears when ignition is enabled and doesn’t disappear
until the moment ignition is disabled. This input is multipurpose, it can operate in accordance with
selected logic.
• Wire 15 (Purple) (CH11) — Factory setting is “Siren”. It connects to siren control wire (+) (maximum
load current is 2A). This channel is multipurpose, it can operate as input or output in accordance
with selected logic.
• Wire 16 (Red) (Power supply +12V) — This wire must be connected to a reliable conductor with
constant voltage of 12V.
Х5 Socket (Relay module)
• Wire 1 (Blue) (CH7) — Factory setting is ‘Blocking N.O.’. This output is used to control blocking relay
with a normally open logic (it becomes grounded on switching on the ignition when the system
is disarmed). An output of additional channel with maximum load current 200mA. This output is
multipurpose, it can operate in accordance with selected logic.
• Wire 2 (Orange) (CH6) — Factory setting is ‘ACC’. The channel is used to control accessories. If
the ‘Car with START/STOP button’ setting is enabled, the channel will control brake pedal during
remote or automatic engine start. An output of additional channel with maximum load current
200mA. This output is multiputpose, it can operate in acordance with selected logic.
• Wire 3 (Brown) (CH9) — Factory setting is ‘Ignition’. This output is used to switch on the ignition.
It allows implementing automatic engine start, turbo timer, ignition support and connecting to
ignition in series (incut). If the ‘Car with START/STOP button’ setting is enabled, the channel will
operate in impulse mode to control the button. A negative output of additional channel with
maximum load current 200mA. This output is multipurpose, it can operate in accordance with
selected logic.
• Wire 4 (Green) (CH8) — Factory setting is ‘Bypass’. Output activates during remote or automatic
engine start. A negative output of additional channel with maximum load current 200mA. This
output is multipurpose, it can operate in accordance with selected logic.
• Wire 5 (Yellow) (CH10) — Factory setting is ‘Starter’. This output is used to switch on the
starter of a car. A negative output of additional channel with maximum load capacity
200mA. This output is multipurpose, it can operate in accordance with selected logic.
It is not recommended to use any other channel as the Starter output.
• Wire 6 (Red) — +12V Power supply of the relay module.