44
Security-service system Pandora Light
• Make a connection in accordance with the “Fuel control input” scheme. To define the current fuel
level, calibration should be performed at least by two points. In some cases fuel level calibration
should be performed by all specified points (for more exact definition).
Fuel level calibration:
• Select the desired sub-level corresponding to the current fuel level. The total number of sublevels
are 12 (listed in the table).
• Enter the programming level 12. The LED indicator will be red and the system will enter to the
sublevel 12-0 (0%). Enter the number of the desired sublevel (10-100%) by pressing the VALET
button (press the button a number of times equals to a digit; pauses between presses should not
exceed 1 second).
• Run the engine no less than in 1 minute, then press VALET button – the data will be sent to the
base unit.
• Press the lock button
to save the setting.
• If you want to cancel the current setting, press the unlock button
.
• Repeat the procedure for the second and next calibration points.
• To exit the programming mode, enter sublevel 12 or press VALET button more than 12 times.
To reset all calibration values, proceed to the sublevel 11 (do not switch on the ignition). Reset
confirmation is performed by pressing the lock button
, exit without confirmation and exit the
menu are performed by pressing the VALET button.
Sublevel Fuel level
12-0 0%
12-1 10%
12-2 20%
12-3 30%
12-4 40%
12-5 50%
12-6 60%
12-7 70%
12-8 80%
To Next Page
Loading...
