Panduit TDP43ME - Installing an Ethernet Port for the TDP43 ME Printer (Win7)

TDP43ME
TDP43ME: PA26305A01_05 Page: 27 of 59 12-2011
Installing An Ethernet Port For The TDP43ME Printer (Win7):
There are three basic steps in installing a TDP43ME printer on an Ethernet port in Windows 7. These are:
1. Install printer on USB port and change printer internal circuitry to Ethernet port active.
2. Obtain the IP address that the printer will use in communicating with the computer. Using NetPS
Control Center software can determine the IP address for the selected printer.
3. Change the port selection to the TCP/IP port by adding the port, using the above found IP address
and selecting it in Devices and Printers.
STEP 1. CHANGING INTERNAL CIRCUITRY
The following steps will guide the installer in changing the internal port circuitry.
In START Menu, click on
DEVICES and PRINTERS.
Highlight the printer to be
controlled by this computer
and right click.
Step 1.A