Pantum BM5100 Series User Manual

60
• Every time when the setup of access point (wireless router) is changed, you must set up the
wireless network of printer again.
3. Connection failure
• Please inspect if the safe mode and password of access point (wireless router) and printer is
correct.
• Inspect the wireless receiving around printer. Signal receiving may be affected if the router is
away from the printer or there is an obstacle between them.
• Turn the power of access point (wireless router) and printer off and then restart them and set up.
• Please check if the access point (wireless router) and the printer are on the same wireless
frequency. If you need to switch wireless frequencies, please refer to “How to switch wireless
frequency”.
4. The following aspects should be inspected if the printer has problems while they
are used in network:
• Inspect if the firewall software blocks communication. If the computer and printer are connected
in the same network but they cannot be searched, the communication might be blocked by
firewall software. Please refer to the user guide of firewall software to turn firewall off and then try
to search the printer again.
• Inspect if the IP address assignment of printer is correct. You can inspect IP address by printing
the network setup information page of printer out.
• Please refer to the following steps to check if printer and computer are in the same network:
1) Select "Command prompt" as shown below.
a. Windows 8/10 system：Select "Search" button in the Start Menu and input "Command
prompt"in search bar，then press the "Enter”button in the keyboard.
b. Windows 7/Vista/XP system：click "Start" menu-"All procedures"-"Attachment"-"Command
prompt ".
2) Input ping and your printer IP address in popup window, and press "Enter" button.
For example: ping XXX.XXX.XXX.XXX(“XXX.XXX.XXX.XXX” is printer IP address)
3) If RTT is indicated in the window, that is to say your printer and computer are in the same
network.If RTT is not indicated in the window, please refer to Chapter 5 to re-configure the printer
wireless network.
Note:
• Please refer to the user guide or consult the manufacturer for information related to
access point (wireless router).

Pantum BM5100 Series Specifications

General

Print Technology	Monochrome Laser
Processor	600 MHz
Memory	512 MB
Operating Systems Compatibility	Windows, Mac OS, Linux
Print Resolution	1200 x 1200 dpi
First Print Out Time	6.9 seconds
Duplex Printing	Automatic
Connectivity	USB, Ethernet
Paper Input Capacity	250 sheets
Output Capacity	150 sheets
Media Types	Plain, Thick, Thin, Cardstock, Label
Media Sizes	A4, A5, A6, B5, Letter, Legal, Executive
Media Weight	60 to 163 g/m²