Digiplex DGP-848 - 35 - Programming Guide
System Trouble Report Codes
System Trouble Restore Report Codes
Special Report Codes
Automatic Report Code Programming
When using Contact ID or SIA Reporting formats (section [550] page 30), default report codes can be programmed
automatically. After automatic defaults are set, they can be changed and the remaining report codes can be set manually.
Section # Description
Sets all the report codes in the following sections to the
default values from the “Automatic Report Codes List”:
[790]
ALL CODES [600] to [718]
[791]
ARMING & DISARMING CODES [600] to [654]
[792]
ALARM & ALARM RESTORE CODES [655] to [680]
[793]
TAMPER & TAMPER RESTORE CODES [681] to [705]
[794]
TROUBLE & TROUBLE RESTORE CODES [706] to [716]
[795] S
PECIAL CODES [717] to [718]
[706]: __ /__ N/A
__ /__ AC Failure
__ /__ Battery Failure
(disconnect or low)
__ /__ Auxiliary Supply
[707]: __ /__ Bell Output (disconnect
or overload)
__ /__ Timer Loss
__ /__ Fire Loop Trbl.
__ /__ N/A
[708]: __ /__ Combus Fault
__ /__ Module tamper
__ /__ Module ROM check
error
__ /__ Module TLM Fail
[709]: __ /__ Module fail to com.
__ /__ Printer fault
__ /__ Module AC failure
__ /__ Module battery failure
[710]: __ /__ Module auxiliary failure
__ /__ Low battery wireless tx.
__ /__ Wireless transmitter
supervision trouble
__ /__ N/A
[711]: __ /__ Tel# 1 fail to com.
__ /__ Tel# 2 fail to com.
__ /__ Tel# 3 fail to com.
__ /__ Tel# 4 fail to com.
[712]: __ /__ TLM restore
__ /__ AC restore
__ /__ Battery failure restore
(disconnect or low)
__ /__ Aux. supply restore
[713]: __ /__ Bell output (disconnect
or overload) restore
__ /__ Timer programmed
__ /__ Fire loop restore
__ /__ N/A
[714]: __ /__ Combus fault restore
__ /__ Module tamper restore
__ /__ Module ROM check
error restore
__ /__ Module TLM restore
[715]: __ /__ N/A
__ /__ Printer fault restore
__ /__ Module AC restore
__ /__ Module battery restore
[716]: __ /__ Module aux. restore
__ /__ Wireless transmitter
battery restore
__ /__ Wireless transmitter
supervision restore
__ /__ N/A
[717]: __ /__ Cold start (sys. shutdown)
__ /__ Warm start (sys. reset)
__ /__ Test report
__ /__ N/A
[718]: __ /__ N/A
__ /__ PC access finished
__ /__ Installer in
__ /__ Installer out
To Next Page
Loading...
