Paradox MG5050+ User Manual

60
MG5050+ Programming Guide
Appendix A
EN 50131 Programming
The following sections describe all the programming required for your panel to be EN 50131 compliant.
To set your panel to be EN 50131 compliant:
1. Enter section [951] to unlock the software and set EN 50131 defaults.
2. Press Enter.
NOTE: All keypads in the system must have anti-tamper enabled in order to be EN 50131 compliant.
EN 50131 Standard System Defaults
The following sections are provide the system defaults that will be set for EN50131 compliancy. The following provides information on sections [700] through
[840].
Zone Tamper and Supervision Options
Table 52: Description of section [700]
Section Option Option Type Description OFF ON
Section [700]
1 Partitioning Partitioning  Disabled

Enabled
2
General system options
Battery charging  350mA

700mA
3 Audible trouble warning (except AC failure)  Disabled

Enabled
4 Audible trouble warning on AC failure  Disabled

Enabled
5 RF jamming supervision RF jamming supervision

Disabled  Enabled
6
General system options
Exit delay termination  Disabled

Enabled
7 Tamper supervision on the bus module

Disabled  Enabled
8 Panel Tamper Panel Tamper Supervision

Disabled  Enabled
Table 53: Description of section [703]
Section Option Option Type Description OFF ON
Section [703]
1
Keypad options 2
One-touch regular arming (also REM3)  Disabled

Enabled
2 One-touch stay arming (also REM3)  Disabled

Enabled
3 One-touch sleep arming (also REM3)  Disabled

Enabled
4 One-touch bypass programming  Disabled

Enabled
5
Arming/disarming options
Restrict arming on battery failure

Disabled

Enabled
6
Restrict arming on tamper failure (zone + bus
module + wireless PGM)

Disabled

Enabled
7
Restrict arming on supervision trouble;
wireless zones & PGM + bus module

Disabled

Enabled
8 Future Use - - - - -
Table 54: Description of section [705]
Option Description OFF ON
Section [705]
1 Future Use - - - -
2 Future Use - - - -
3
Tamper recognition (see following table)

Disabled  Enabled
4  Disabled

Enabled
5 Generate tamper on bypassed zone  No
 Ye s
6
Supervision options (see following table)

Disabled  Enabled
7  Disabled

Enabled
8 Generate supervision on bypassed zone

No  Ye s
= Default

Paradox MG5050+ Specifications

General

Partitions	2
PGMs	16
Wireless Zones	32
StayD Mode	Yes
Number of Zones	32
Wireless	Yes
Remote Control	Yes, via remote controls and app
Power Supply	16.5 V AC
Battery Backup	7Ah
Zones	32 (8 on-board)