Page 24 Configuring the PCS250G
Arm/Disarm System via Text Message
It is possible to arm or disarm your system by sending an SMS
text message from any cell phone. The message must be sent to
the PCS250G’s phone number, as determined by the cell phone
network provider.
Note: This feature is available only seven minutes after a power-up
sequence or seven minutes after a SIM card switch.
The text message command has a specific format and specific
elements that must be sent to the phone number of the PCS250G
module. The format is as follows:
SMS Text Message Format
C[USER CODE].[ACTION].A[PARTITIONS].[PHONE NUMBER]
Examples
Arming - C1234.ARM.A5.5555551234
Disarming - C1234.OFF.A5.5555551234
Multiple partitions - C1234.ARM.A1,3,5TO7.5555551234
To Next Page
Loading...
