Page 18 Configuring the PCS250G
Configuring WinLoad Access
The PCS250G GPRS Communicator Module provides remote
access for upload and download with WinLoad via a GPRS
connection. The following site specific sections must be
configured for WinLoad access.
Note: In the case where a reportable event occurs while a WinLoad
session is active via GPRS, the communication is terminated to allow
event reporting.
Programming and Registering GPRS Reporting
Options
The following sections describe the options that must be
programmed in the panel for GPRS reporting. Control panels with
a PCS250G can also report system events to a monitoring
station’s IPR512 GPRS/IP Monitoring Receiver.
MG/SP/E EVO Feature Details
[920] [2966] Software port Default: 10000
[927] [3013] Password Default: admin
MG/
SP/E
EVO Feature Details
[918]
[919]
[2976] Account /
partition
registration
MG/SP/E: sections
represent account /
partition 1 & 2
EVO: sections represent
account / partition 1 to 8
to
[2983]
[806] [2975] [7] Off + [8] Off = Landline only
[7] Off + [8] On = GPRS primary / landline
backup (default)
[7] On + [8] Off = Landline only
[7] On + [8] On = Landline & GPRS in parallel
To Next Page
Loading...
Need help?
General
