Paradox PCS250G User Manual

Page 28 Module Supervision
Chapter 6: Module Supervision
The PCS250G provides several supervision options to ensure that
you or your monitoring station is notified of problems such as
loss of GPRS service or loss of communication with the control
panel.
Unique to Paradox, the PCS250G can supervise the presence of
the control panel. If communication with the control panel is lost,
the PCS250G will send an SMS message.
The PCS250G verifies the presence of the GSM cell phone
network approximately every 20 seconds. If the connection is
lost, the panel can generate an alarm or trouble after the delay
has elapsed (programmed in section [2952] for EVO or [855] for
MG/SP). When the GSM network connection is lost, the SIM card
LED is no longer steady on.
Important: It is highly recommended to set section (SP Series
[885], EVO Series [2952] at a higher value than 120 seconds (4
minutes) due to the latency of the GSM network.
MG/
SP/E
EVO MG/SP/E Details EVO Details
[805] [2950] [5] Off + [6] Off =
Module supervision
disabled
[5] Off + [6] On =
Armed: generates a
trouble (default)
[5] On + [6] Off =
Armed: generates an
audible alarm
[5] On + [6] On =
Silent alarm
becomes an audible
alarm
[5] Off + [6] Off =
Module supervision
disabled
[5] Off + [6] On =
Armed: generates an
audible alarm
[5] On + [6] Off =
Armed: generates a
trouble (default)
[5] On + [6] On =
Silent alarm becomes
an audible alarm
[855] [2952]
Set the delay before a GSM No Service trouble
is reported. (000 - 255 x 2 sec. / default: 016
(32 sec.)

Paradox PCS250G Specifications

General

Brand	Paradox
Model	PCS250G
Category	Cell Phone
Language	English