Paradox PCS250G User Manual

Overview Page 9
Once the PCS250G’s tamper switch is closed, the panel will reset
the trouble message and a tamper restore message will be sent
to the monitoring station and to the SMS recipients. Also, upon
the closure of the PCS250G’s tamper switch there is a 30s delay
before the PCS250G sends out a “tamper close” status to the
panel.
The PCS250G GPRS Communicator Module’s tamper functionality
is supported with a compatible Paradox control panel.
• MG/SP v4.90 and higher
• EVO192 v2.71 or higher
• SP4000/SP65 v5.10 or higher
• IP150 v2.0 or higher
Specifications
The following table describes the technical specifications of the
PCS250G GPRS Communicator Module.
Power Class 4 (2W) @ 850/900 MHz
Class 2 (1W) @ 1800/1900 MHz
Antenna Bandwidth 70 / 80 / 140 / 170 MHz
Antenna Gain <3dBi; impedance 50 ohm
Input power >2W peak power
Power Input 12Vdc nominal
Consumption 100 mA standby, average 450mA (1.2A
peak) during GPRS transmission
Operating
Temperature
0ºC to 50ºC (32ºF to 122ºF)
Encryption 128-bit (MD5 and RC4) or 256-bit (AES)
SMS Protocol 8-bit (ISO/IEC 8859-1) or 16-bit (UCS2
ISO/IEC10646)
Humidity 5-90%
Weight 200 gr (7.05 oz)
Dimensions 17.2 x 9.8 x 4.4 cm (6.8 x 3.9 x 1.7 in.)
Certification EN 50136 ATS 5 Class II, Certification
Body Intertek

Paradox PCS250G Specifications

General

Brand	Paradox
Model	PCS250G
Category	Cell Phone
Language	English