Programming:
STEP KEY DESCRIPTION
1. RESET Clears control’s memory. Control is finished initializing when # stops flashing
(about 6 seconds).
2. NEXT Display shows MAINtAin (maintained relay operation).
3. PROGRAM Display shows TIME header.
4. NEXT,+,- Use these keys to set time, date and daylight savings time information.
5. PROGRAM Press PROGRAM key to step through headers until EVNT (event header) is
reached.
6. NEXT First event is shown with event # flashing.
7. NEXT Event type is flashing.
8. + Select OFF event type.
9. NEXT Channel no.1 is flashing. This is the desired channel.
10. NEXT Hours are flashing.
11. - Roll backward to select 5 PM.
12. NEXT Minutes are flashing. 00 is desired value.
13. NEXT SUN is flashing. NO is displayed
14. NEXT MON is flashing. NO is displayed.
15. + Change NO to YES. Step through remaining days and select YES for TUE,
WED, THU, FRI and HOLIDAY A.
37
To Next Page
Loading...
