STEP KEY DESCRIPTION
16. PROGRAM Advance to INPT (configure inputs) header.
17. NEXT 1st input is shown with input # flashing.
18. NEXT Input type is flashing.
19. +/- Select F (Fahrenheit).
20. NEXT CAL (calibration) offset is shown.
21. +/- Calibrate sensor if necessary.
22. PROGRAM Advance to EVNT SENS (sensor event) header.
23. NEXT First sensor event is shown with event # flashing.
24. NEXT Sensor no. is flashing. NONE indicates that a sensor has not yet been selected.
25. + Select sensor 1. 1- F is displayed.
26. NEXT Channel no. 1 is flashing. This is the desired channel.
27. NEXT Hours are flashing.
28. + Roll hours to 8 AM (PM indicator is not displayed).
29. NEXT Minutes are flashing. 00 is desired value.
30. NEXT SUN is flashing, NO is displayed. Step through the days to select YES for
MON, TUE, WED, THU and FRI.
31. NEXT ON is displayed with the on setpoint flashing.
32. + Roll to 074F.
38
To Next Page
Loading...
