PARAMOUNT BED CA-53380 - Installation Guidelines

■
To avoid possible malfunctions, do not install the bed in the following
●
Locations expose to direct sunlight
●Locations near heat sources such as a stove or heater
●Location which is heavily electrically charged such as near an MRI
●Location that has a high oxygen level
●Locations exposed to excessive amounts of water vapor or oil vapor
●Location that tend to be exposed to high temperatures, high humidity, low temperatures
or dry conditions
※The optimum ambient conditions for the bed are as follows.
Temperature 5℃ to 40℃ / Humidity 20%RH to 90%RH at 30℃ / Atmospheric pressure
700hPa to 1060hPa.
●Locaitons with large amount of dust, smoke, salt, sulfur, or corrosive substances
●Locations with poor ventilation
●Locations exposed to vibrations or shocks (including during transportaion)
●Locations where the floor is not strong enough
●Locations where the floor is not level
13
Secure at least 20 cm clearance from the wall.
INSTALLATION
3
●
The bed or wall may be damaged or deformed. Make
sure that the bed does not hit the wall, beam, or power
plug during the height adjustment or inclination angle
adjustment.
■
When performing the height adjustment or inclination angle adjustment, pay attention
not to hit the wall, beam, or power outlet on the wall.
■
When setting up the bed, make sure that there is at least 20 cm clearance from the wall.
●
The main frame moves back and forth during the
height adjustment or inclination angle adjustment
and could hit the wall, causing damage or
deformation of the bed.